Cisco 1 Net Fun practice final Final 4

Last Updated By FunnelBrain1 on 05/17/2013
90 people took this quiz
  • Share
http%3A%2F%2Fwww.funnelbrain.com%2Fqc-189090-which-of-the-following-are-address-ranges-of-the-private-ip-addresses-choose-3.html

Which subnet mask will allow 2040 hosts per subnet on the IP network 10.0.0.0?

Answer:
a)  255.255.0.0
b)  255.255.254.0
c)  255.255.252.0
d)  255.255.248.0
e)  255.255.240.0
f)  255.255.255.128
View as Flashcard Quiz
Related Quiz Content
  • FunnelBrain1
    Refer to the exhibit. RouterB is configured properly. The Ethernet interface Fa0/0 of RouterA is configured with the use of the commands that are shown. However, a ping from the Fa0/0 interface of RouterA to the Fa0/0 interface of RouterB is unsuccessful. What action should be taken on RouterA to solve this problem?
    Refer to the exhibit. RouterB is configured properly. The Ethernet interface Fa0/0 of RouterA is configured with the use of the commands that are shown. However, a ping from the Fa0/0 interface of RouterA to the Fa0/0 interface of RouterB is unsuccessful. What action should be taken on RouterA to solve this problem?
    a)Use the description command on the FastEthernet interface Fa0/0.
    b)Configure the clock rate of the FastEthernet interface Fa0/0.
    c)Use the no shutdown command on the FastEthernet interface Fa0/0.
    d)Reboot the router.
    c)Reboot the router.
  • FunnelBrain1
    To send data through a network, what two flags are used to establish a session? (choose 2)
    a)ACK
    b)CRC
    c)SYN
    d)Ack #
    e)Port #
    f)Seq #
    c)Seq #
  • FunnelBrain1
    Which statement is true about the TTL value of an IPv4 packet?
    a)It determines the priority of a packet
    b)It specifies the remaining "life" of the packet
    c)It indicates that the packet has been fragmented
    d)It denotes the data payload type that the packet is carrying
    b)It denotes the data payload type that the packet is carrying
  • FunnelBrain1
    Refer to the exhibit. Communication for hosts X and Y is restricted to the local network. What is the reason for this?
    Refer to the exhibit. Communication for hosts X and Y is restricted to the local network. What is the reason for this?
    a)Host X is assigned a network address
    b)Host Y is assigned a multicast address
    c)Host X and host Y belong to different networks
    d)The gateway addresses are broadcast addresses
    d)The gateway addresses are broadcast addresses
  • FunnelBrain1
    What type of network is maintained if a server takes no dedicated role in the network?
    a)mainframe
    b)client/server
    c)peer-to-peer
    d)centralized
    c)centralized
  • FunnelBrain1
    A routing issue has occurred in your internetwork. Which of the following type of devices should be examined to isolate this error?
    a)access point
    b)host
    c)hub
    d)router
    e)switch
    d)switch
  • FunnelBrain1
    Which physical component is used to access and perform the initial configuration on a new unconfigured router?
    a)Which physical component is used to access and perform the initial configuration on a new unconfigured router?
    b)Which physical component is used to access and perform the initial configuration on a new unconfigured router?
    c)Which physical component is used to access and perform the initial configuration on a new unconfigured router?
    d)Which physical component is used to access and perform the initial configuration on a new unconfigured router?
    e)Which physical component is used to access and perform the initial configuration on a new unconfigured router?
    b)Which physical component is used to access and perform the initial configuration on a new unconfigured router?
  • FunnelBrain1
    A user sees the command prompt: Router(config-if)#. What task can be performed at this mode?
    a)Reload the device
    b)Perform basic tests
    c)Configure individual interfaces
    d)Configure individual terminal lines
    c)Configure individual terminal lines
  • FunnelBrain1
    What is the correct order for PDU encapsulation?
    a)What is the correct order for PDU encapsulation?
    b)What is the correct order for PDU encapsulation?
    c)What is the correct order for PDU encapsulation?
    d)What is the correct order for PDU encapsulation?
    a)What is the correct order for PDU encapsulation?
  • FunnelBrain1
    What information can be gathered by using the command netstat?
    a)the default gateway
    b)the routing protocol
    c)active TCP connections
    d)the locally configured subnet mask
    c)the locally configured subnet mask
Discussion Board
Cisco 1 Net Fun practice final Final 4
Cisco 1 Net Fun practice final Final 4
Quiz Taken:90 people took this quiz
Rate this Quiz
Teams
Quiz does not belong to any team.
Quiz Tags
Others Studying this Quiz
Free Quiz Question From Cisco 1 Net Fun practice final Final 4
Question: Which subnet mask will allow 2040 hosts per subnet on the IP network 10.0.0.0?
Answer:
255.255.0.0
255.255.254.0
255.255.252.0
255.255.248.0
255.255.240.0
255.255.255.128