CTEC 294

Last update by Shanal on 11/07/2013
49246 People have viewed this Quiz
  • Share

During the ____ formatting process, you specify the size of the partition and what file system it will use.

Answer:
high-level

View CTEC 294 as Flashcard Deck

Related Quiz Content
  • kbbrown05 kb
    Answered in CTEC 294

    DIMMs intended to be used in servers must be extremely reliable and use an error-checking technology called ____.

    ECC
  • kbbrown05 kb
    Answered in CTEC 294
    With ____, you can connect and disconnect a drive while the system is running.
    hot-swapping
  • kbbrown05 kb
    Answered in CTEC 294

    If the number of bits is not an odd number for odd parity or an even number for even parity, a ____ error occurs.

    parity
  • kbbrown05 kb
    Answered in CTEC 294

    ____ is a system BIOS feature that monitors hard drive performance, disk spin up time, temperature, distance between the head and the disk, and other mechanical activities of the drive in order to predict when the drive is likely to fail.

    S.M.A.R.T.
  • kbbrown05 kb
    Answered in CTEC 294

    In the table found in the motherboard manual, a chip on a RIMM module is called a ____.

    component

  • kbbrown05 kb
    Answered in CTEC 294

    If the chip’s surface is dull or matted, or you can scratch off the markings with a fingernail or knife, suspect that the chip has been ____.

    re-marked

  • kbbrown05 kb
    Answered in CTEC 294

    With ____, two hard drives are configured as a single volume.

    spanning
  • kbbrown05 kb
    Answered in CTEC 294

    ____ loses its data rapidly, and the memory controller must refresh it several thousand times a second.

    Dynamic RAM
  • kbbrown05 kb
    Answered in CTEC 294

    A drive ____ is a duplication of everything written to a hard drive.

    image
  • kbbrown05 kb
    Answered in CTEC 294

    Almost all hard drives sold today for desktop computers are magnetic hard drives.

    True
  • kbbrown05 kb
    Answered in CTEC 294
    he ATA interface standards are developed by Technical Committee T13 and published by ____.
    ANSI